Match the card to your LED modules
The DH7516-S is a NovaStar receiving card with 16 HUB75E connectors and support for up to 32 groups of parallel RGB data. Check the module pinout and driver IC before wiring a cabinet.
The pixel limit depends on the driver IC. At 60 Hz, NovaStar specifies up to 512 × 512 pixels with PWM driver ICs and up to 512 × 384 with common driver ICs.
Cabinet setup
Use NovaLCT 5.3.0 or later to configure the cabinet. The card supports pixel-level brightness and chroma calibration, independent RGB gamma adjustment, 3D, 90° rotation and dual-card backup.
| ബ്രാൻഡും മോഡലും | നോവാസ്റ്റാർ DH7516-S |
|---|---|
| ഉൽപ്പന്ന തരം | LED ഡിസ്പ്ലേ സ്വീകരിക്കുന്ന കാർഡ് |
| ഔട്ട്പുട്ട് | 16 × ഹബ്75ഇ |
| സമാന്തര RGB ഡാറ്റ | 32 ഗ്രൂപ്പുകൾ വരെ |
| PWM ഡ്രൈവർ ഐസികളിൽ പരമാവധി ലോഡ് | 60 Hz-ൽ 512 × 512 പിക്സലുകൾ |
| സാധാരണ ഡ്രൈവർ ഐസികളിൽ പരമാവധി ലോഡ് | 60 Hz-ൽ 512 × 384 പിക്സലുകൾ |
| കോൺഫിഗറേഷൻ സോഫ്റ്റ്വെയർ | നോവഎൽസിടി 5.3.0 അല്ലെങ്കിൽ അതിനുശേഷമുള്ളതും വി-കാനും |
| ഡിസ്പ്ലേ ഫംഗ്ഷനുകൾ | Pixel-level brightness and chroma calibration, independent RGB gamma, 3D and 90° rotation |
| ആവർത്തനം | ഡ്യുവൽ-കാർഡ് ബാക്കപ്പ് |
| EMC പാലിക്കൽ | ക്ലാസ് ബി |


സ്പെസിഫിക്കേഷൻ ഡൗൺലോഡുകൾ
സാധാരണ ചോദ്യങ്ങൾ
Which pixel limit should I use?
Use the limit for the driver IC in your modules. Use 512 × 384 at 60 Hz for common driver ICs and 512 × 512 at 60 Hz for PWM driver ICs, subject to the module and cabinet configuration.
Can I use the same module cables when replacing a card?
Compare the module connector pinout with the DH7516-S pinout in the specification before reusing cables. Save your cabinet configuration before changing cards.



