Match the card to your LED modules
The DH7516-S is a NovaStar receiving card with 16 HUB75E connectors and support for up to 32 groups of parallel RGB data. Check the module pinout and driver IC before wiring a cabinet.
The pixel limit depends on the driver IC. At 60 Hz, NovaStar specifies up to 512 × 512 pixels with PWM driver ICs and up to 512 × 384 with common driver ICs.
Cabinet setup
Use NovaLCT 5.3.0 or later to configure the cabinet. The card supports pixel-level brightness and chroma calibration, independent RGB gamma adjustment, 3D, 90° rotation and dual-card backup.
| ម៉ាកនិងម៉ូដែល | NovaStar DH7516-S |
|---|---|
| ប្រភេទផលិតផល | កាតទទួលអេក្រង់ LED |
| លទ្ធផល | ១២ × HUB75E |
| ទិន្នន័យ RGB ស្របគ្នា | រហូតដល់ ៨ ក្រុម |
| បន្ទុកអតិបរមាជាមួយ IC កម្មវិធីបញ្ជា PWM | ៥១២ × ៥១២ ភីកសែល នៅ ៦០ ហឺត |
| បន្ទុកអតិបរមាជាមួយ IC កម្មវិធីបញ្ជាទូទៅ | ៥១២ × ៥១២ ភីកសែល នៅ ៦០ ហឺត |
| ផ្នែកទន់កំណត់រចនាសម្ព័ន្ធ | NovaLCT 5.3.0 ឬថ្មីជាងនេះ និង V-Can |
| មុខងារបង្ហាញ | Pixel-level brightness and chroma calibration, independent RGB gamma, 3D and 90° rotation |
| ការលែងត្រូវការតទៅទៀត | ការបម្រុងទុកកាតពីរ |
| ការអនុលោមតាម EMC | ថ្នាក់ B |


ការទាញយកលក្ខណៈបច្ចេកទេស
សំណួរទូទៅ
Which pixel limit should I use?
Use the limit for the driver IC in your modules. Use 512 × 384 at 60 Hz for common driver ICs and 512 × 512 at 60 Hz for PWM driver ICs, subject to the module and cabinet configuration.
Can I use the same module cables when replacing a card?
Compare the module connector pinout with the DH7516-S pinout in the specification before reusing cables. Save your cabinet configuration before changing cards.



