Colorlight 5A-75E is an LED display receiving card with integrated HUB75 outputs for connecting LED modules without a separate HUB adapter board. Colorlight lists a maximum loading area of 512 × 512 pixels and 32 parallel RGB data groups for the 5A-75E/5A-75B family. Confirm the cabinet wiring and actual load in your configuration before installation.
Key features
- Integrated HUB75: direct module connections can reduce adapter boards and plug-in connectors.
- Display control: supports high refresh, grayscale performance and brightness/chroma pixel calibration with compatible LED driver chips.
- Creative layouts: data offset and mapping options support irregular LED cabinets and shaped displays.
- System reliability: Colorlight describes loop redundancy and firmware redundancy for this receiving-card family; configure and test the corresponding sending system for the intended installation.
5A-75E specifications at a glance
| Item | Specification |
|---|---|
| Product type | LED display receiving card |
| Module interface | Integrated HUB75 |
| Maximum load | 512 × 512 pixels |
| RGB data output | 32 parallel RGB data groups |
| Calibration | Pixel-level brightness and chroma calibration |
Compatibility and setup
Use the 5A-75E with a compatible Colorlight sending device and match the receiver configuration to the LED module’s HUB75 pinout, scan pattern and driver chips. The maximum 512 × 512 load is a card limit, not a guarantee that every cabinet layout or refresh setting will support that size. Check your hardware revision and cabinet requirements against the Colorlight 5A-75E/5A-75B product information and the specification PDF below.
Frequently asked questions
Does the 5A-75E need a separate HUB board?
It has integrated HUB75 outputs, so a separate HUB adapter board is generally unnecessary when the LED modules and wiring match the card.
What is the maximum loading area?
Colorlight states up to 512 × 512 pixels. The usable area depends on the module, scan mode and system configuration.
Where can I find the 5A-75E manual?
Download the receiving-card specification below for pinout, installation and revision-specific details.
Conclusion
The Colorlight 5A-75E combines direct HUB75 module connections with a manufacturer-stated 512 × 512 maximum load and 32 parallel RGB data groups. Verify your module wiring and sending-device configuration before ordering or replacing a card.
More Pictures of ColorLight 5A-75E LED Display Receiving Card:
Download Specification:
–Colorlight-5A-75E-Receiving-Card-Specification.pdf
